What element is used to cross-link the hydrocarbon chains when natural rubber undergoes vulcanization?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “What element is used to cross-link the hydrocarbon chains when natural rubber undergoes vulcanization? ...” in 📘 Chemistry if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
What parameter must remain the same for k to be a constant in the rate law equation? Temperature Pressure Volume Activation energy
Answers (1)
A liquid's temperature is lowered from 60°C to 10°C. Did the the liquid's vapor pressure increase, decrease, or stay the same during that time?
Answers (1)
Which of the following is an advantage of the sole proprietorship form of ownership? A. Limited liability B. Split responsibility C. Control over the business D. Unlimited liability
Answers (2)
A solution of NaOH has a concentration of 25.00% by mass. What mass of NaOH is present in 0.250 g of this solution? Use the periodic table in the toolbar if needed. 0.
Answers (2)
An element that is malleable and a good condcutor of heat and electricity could habe an atomic number of
Answers (1)
New Questions in Chemistry
Determine the number of grams of NaCl necessary to make up 100 mL of a 0.10 M solution. 0.017 g 0.58 g 1.7 g 58 g
Answers (1)
What causes an increase in the average global temperature?
Answers (1)
Which of the following is true regarding nuclear fission and nuclear fusion? A. Both of these processes can provide energy. B. Our sun's heat is an example of both of these processes. C. Both of these processes are equally complex to control. D.
Answers (1)
It takes 5.2 minutes for a 4.0 g sample of francium-210 to decay until only 1.0 g is left. What is the half-life of francium-210? 7.8 minutes 1.3 minutes 2.6 minutes 5.2 minutes
Answers (1)
What is the correct orbital diagram for carbon
Answers (1)