Ask Question
1 July, 22:45

What system of representation is used for the threaded portions

+4
Answers (1)
  1. 1 July, 23:21
    0
    I'd say conventional representation.

    The representation of threaded parts in drawings depends on the type of screw applied. Both the screw thread and its dimensions are to be indicated by standards designations. A draftsman should be in position to draw the true projection of a thread and is always important that he follows some conventional methods to represent screw threads.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “What system of representation is used for the threaded portions ...” in 📘 Computers and Technology if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers