Ask Question
17 May, 23:21

An engineer disassembles a lawnmower and notices an unusual wear pattern on a moving part. Following the Reverse Engineering process, the engineer documents the material used and justification for an improved material. Which part of the Reverse Engineering process did the engineer perform in this procedure?

+4
Answers (1)
  1. 17 May, 23:52
    0
    Reverse Engineering is usually performed with the intention to construct a new device, program or parts that does the same thing without actually copying anything from the original. The r esulting knowledge gained can then be applied to the design of similar products and that capitalizing on successes and learning from the shortcomings of existing designs.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “An engineer disassembles a lawnmower and notices an unusual wear pattern on a moving part. Following the Reverse Engineering process, the ...” in 📘 Computers and Technology if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers