Ask Question
20 November, 21:13

Which of the following correct modes, can be used to apply loopback policy?

Select one or more:

a. Merge mode

b. Replace mode

c. Remote mode

d. Local mode

+5
Answers (1)
  1. 21 November, 00:03
    0
    Answer: (A) Merge mode and (B) Remote mode

    Explanation:

    The merge and remote mode is basically used in the loop-back policy. The loop back policy is used in the computer configuration as the group policy of the management editor.

    The loop-back policy is basically allowed the administrator for access the setting of the group policy. When the merge mode are enable in the loop back policy then, the computer configuration are basically based on the particular computer configuration that are located in the computer active directory.

    Remote mode is also used to apply in the loop back policy and when this mode enabled then, it change the user configuration. In the active directory of the replace mode the user settings is basically based on the configuration of the user setting.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Which of the following correct modes, can be used to apply loopback policy? Select one or more: a. Merge mode b. Replace mode c. Remote ...” in 📘 Computers and Technology if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers