Ask Question
8 July, 16:08

Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle (WOT). Technician B says A TP sensor can be tested using a DMM, DSO, or scan tool. Who is right?

+4
Answers (1)
  1. 8 July, 17:42
    0
    Both are right.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle ...” in 📘 Computers and Technology if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers