Ask Question
10 September, 01:52

How should you set the OHMS ADJust control on a multitester of analog VOM, for resistance measurements?

+2
Answers (1)
  1. 10 September, 04:29
    0
    In my day (my next door neighbor was a brontosaurus rex), there was a wheel on the front panel.

    You shorted the input leads when the master switch was turned to ohms. Then you adjusted the wheel so that the meter read 0 on the right hand side of the scale. The zero is clearly marked. The ohmmeter on an analog Vom reads 0 on the right. Everything else has its zero on the left.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “How should you set the OHMS ADJust control on a multitester of analog VOM, for resistance measurements? ...” in 📘 Computers and Technology if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers