Ask Question
1 December, 23:20

While setting up a new network, a technician connects two switches together using a Cat6 straight-through cable. The switch ports are configured for 1000BaseT Ethernet, full-duplex, and do not support auto-MDIX. After making the connection, the link status light for both ports remains off. What is the most likely problem?

+3
Answers (1)
  1. 2 December, 00:24
    0
    The problem may arise is the termination of the cable is wrong.

    Explanation:

    When we set up a new connection in the organization the cable plays an important role in it. In this question we have to create the new network, the professional is using the straight-through Cat6 for linking in the switching The switches do not support the Auto Mdix as it supports only full-duplex, so we have to check the Cabling.

    The incorrect Cable termination problem will not support the Auto Mdix Sometimes the Auto Mdix problem is arising because of the wrongful termination of the cable we have to check the connection of power cabling for the effective use.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “While setting up a new network, a technician connects two switches together using a Cat6 straight-through cable. The switch ports are ...” in 📘 Computers and Technology if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers