The radiator of a steam heating system has a volume of 35 L and is filled with superheated water vapor at 200 kPa and 200°C. At this moment, both the inlet and the exit valves to the radiator are closed. After a while it is observed that the temperature of steam drops to 80°C as a result of heat transfer to the room air, which is at 21°C. Assume the surroundings to be at 0°C.
Determine the entropy change of the steam during this process.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “The radiator of a steam heating system has a volume of 35 L and is filled with superheated water vapor at 200 kPa and 200°C. At this ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Higher molecular weight results in worst mechanical properties. a) - True b) - false?
Answers (1)
5.46 By supplying energy at an average rate of 24,000 kJ/h, a heat pump maintains the temperature of a dwelling at 20°C. If electricity costs 8.
Answers (1)
2. A water pump that consumes 2 kW of electric power when operating is claimed to take in water from a lake and pump it to a pool whose free surface is 30 m above the free surface of the lake at a rate of 50 L/s.
Answers (1)
An engineer devises a scheme for extracting some power from waste process steam. The engineer claims that the steam enters the device at 340 F and quality 75%, and exits at 220 F and 65% quality.
Answers (1)
To get an accurate pressure reading, the tires must be checked when cold. True or False
Answers (1)
New Questions in Engineering
List two types of inferred values used to indicate level measurements
Answers (1)
Yo can someone find me an e-boy?
Answers (1)
If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile
Answers (1)
A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.
Answers (1)
What design advantages can you identify in the location of the controller
Answers (1)