Engineering

Kyle Harmon

21 April, 16:33

Gasoline flows through the 2 cm diameter hose in a gas station at a speed of 0.7 m/s. If the gas tank in my car has a capacity of 10.6 gallons (0.04 m3), how long does it tank to fill my gas tank? If the density of gasoline is 708 kg/m3, what is the mass flow rate of gasoline in the hose?

+5

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question ✅ “Gasoline flows through the 2 cm diameter hose in a gas station at a speed of 0.7 m/s. If the gas tank in my car has a capacity of 10.6 ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.

Search for Other Answers

You Might be Interested in

A reversible heat pump and a Carnot heat pump operate between the same two thermal reservoirs. Which heat pump has higher COP?

What are nonexecuting statements that you can use to document or add notes to assist in the use of the program?

Internal flow is one in which the flow is not bounded. a) True b) False

There is no difference in boring and drilling. a) - True b) - False

Extensive property means and explain Example of extensive property.

New Questions in Engineering

Our goal is to design a traffic-light controller with the following properties; it lights up the green light (output G) for 15 seconds, followed by the yellow light (output Y) for 9 seconds, then the red light (output R) for 12 seconds.

What is manufacturing?

A college course may have one or more scheduled sections, or may not have a scheduled section. Attributes of Course include courseID, courseName, and units. Attributes of Section include sectionNbr and semester.

A large fraction of the thermal energy generated in the engine of a car is rejected to the air by the radiator through the circulating water. Should the radiator be analyzed as a closed system or an open system?

In an orthogonal cutting operation, if the friction coefficient between the tool and the chip is decreased while the material and the rake angle are kept constant, then the shear angle will increase. True False