Hogden is conducting an experiment to determine how much force it takes for a nail to puncture a tire, causing a flat. He uses five identical nails and tests them on five identical tires filled with equal amounts of air. He hits each nail one time, applying a different force each time. His results are recorded below. Trial Force (lbs) Result nail 1 15.0 no flat nail 2 30.0 no flat nail 3 45.0 no flat nail 4 60.0 flat nail 5 75.0 flat What can Hogden conclude from his results? A. It takes exactly 60.0 pounds of force on the nail to cause a flat. B. It takes exactly 45.0 pounds of force on the nail to cause a flat. C. It takes between 60.0 and 75.0 pounds of force on the nail to cause a flat. D. It takes between 45.0 and 60.0 pounds of force on the nail to cause a flat.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Hogden is conducting an experiment to determine how much force it takes for a nail to puncture a tire, causing a flat. He uses five ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Which of the following bonding is the strongest? (a) lonic bonding (b) Metallic bonding (c) Covalent bonding with some van der Waals bonding (d) van der Waals bonding
Answers (1)
Two parallel plates, one moving at 4 m/s and the other fixed, are separated by a 5-mm-thick layer of oil of specific gravity0.80 and kinematic viscosity 125 E4 mzls.
Answers (1)
g 2000 m3/d flow from a dairy industry is treated in an activated sludge plant. The BOD5 is 300 mg/L, and most of it is in soluble form.
Answers (1)
Given two resistors R1=40 ohm and R2=30 ohm connected in series, what is the total resistance of this configuration? Enter the value in the box below without the unit. Round the result to two decimal places if necessary.
Answers (1)
when testing transistors, how much minimum voltage difference should be seen across the base-emitter junction? A. 0.1 VDC B. 0.4 VDC C. 0.6 VDC D. 0.9 VDC
Answers (1)
New Questions in Engineering
If you touch a downed power line, covered or bare, what's the likely outcome?
Answers (1)
given two continuous time signals x (t) and h (t), if their convultion is denoted by y (t), then the convultion of x (t-1) and h (t+1) is
Answers (1)
Old cars used to have a purely mechanical device called a carburetor to draw fuel into the engine for combustion. (Modern cars accomplish this with electronic fuel injection systems.
Answers (1)
A gardener is using a 60N wheelbrow to carry 250Nb bag. The force exerted to each handle by gardener is 42 N, The force and the moment at the wheels are respectivelty: a. Fy=-226 N, M=25 N. m b. Fy=84 N, M=0 c. FX=100 N, M = 226 N. m d.
Answers (1)
A painting crew reported that a job is 35 completed. What fraction of the job remains to be done?
Answers (1)