An alloy to be used for a spring application must have a modulus resilience of at least 0.72 * 106 J/m3 (0.72 * 106 Pa). What must be its minimum yield strength (in MPa) ? Assume that the modulus of elasticity for this alloy is 101 GPa.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “An alloy to be used for a spring application must have a modulus resilience of at least 0.72 * 106 J/m3 (0.72 * 106 Pa). What must be its ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
In this type of projection, the angles between the three axes are different: - A) Isometric B) Axonometric C) Trimetric D) Dimetnic
Answers (1)
What is the pressure drop when a liquid (viscosity = 0.001 Pa-s, density = 1000 kg/m3) flows at a rate of 40 liters/minute over a 2-cm diameter steel pipe that is 100 meters long? Effective roughness factor (k) is 0.046 mm.
Answers (1)
A 600 MW coal-fired power plant has an overall thermal efficiency of 38%. It is burning coal that has a heating value of 12,000 Btu/lb, an ash content of 5%, a sulfur content of 3.0%, and a CO2 emission factor of 220lb/million Btu.
Answers (1)
What happened to the speed when net force is big
Answers (1)
How could the location of tests affect the performance of a catapult?
Answers (2)
New Questions in Engineering
A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.
Answers (1)
What design advantages can you identify in the location of the controller
Answers (1)
A dam 75 ft wide, with a nominal flow rate of 260 ft3/s, is to be studied with a scale model 3 ft wide, using Froude scaling as the most important similarity parameter.
Answers (1)
The primary heat transfer mechanism that quickly warms my hand if I hold it directly above a campfire is: a) - Radiation b) - Inductance c) - Convection d) - Conduction
Answers (1)
A long thin copper rod (K = 377 W/m K) 10 mm in diameter is exposed to an environment at 22 oC. The base temperature of the rod is maintained at 150 oC. The heat transfer coefficient between the rod and the environment is 11 W/m2 K.
Answers (1)