Engineering

Anahi Pittman

16 October, 22:47

While discussing armature testing: Technician A says to test for shorts, place the ohmmeter leads on a commutator segment and armature shaft. Technician B says that continuity should exist between the commutator and the armature shaft. Who is correct?

+1

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question ✅ “While discussing armature testing: Technician A says to test for shorts, place the ohmmeter leads on a commutator segment and armature ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.

Search for Other Answers

You Might be Interested in

If you have a mold with one sprue, three runners and six gates and you want a gating ratio of 1:4:6 and the bottom of the sprue is 1 in2, what is the width of each runner and gate

Define the difference between yield stress and proof stress

A teenager was pulling a prank and placed a large stuffed penguin in the middle of a roadway. A driver is traveling on this level roadway and sees the penguin 525 feet ahead.

2. Name three types of roofing that might be suitable for covering large areas quickly.

The term motion refers to a change in position with respect to a. a specific reference b. the ground c. the center of the Earth d. the Sun

New Questions in Engineering

Between a hypothesis and a prediction

A local reaction is when a chemical enters the bloodstream?

The rules for ordinary arithmetic involving addition, subtraction, and multiplication carry over into modular arithmetic. Tru

An air-conditioning system is used to maintain a house at 70°F when the temperature outside is 100°F. The house is gaining heat through the walls and the windows at a rate of 800 Btu/min, and the heat generation rate within the house from people,

The electricity we use is static or current electricity?