Ask Question
EngineeringEngineering
21 March, 16:04

Electrical circuits must be locked-out/tagged-out before electricians work on any equipment. Is this true or false?

+2
Answers (2)
  1. 21 March, 17:15
    0
    true. this way they don't get shocked or electrocuted.
  2. 21 March, 18:26
    0
    True

    Explanation:

    A locked/tagged out procedure is used to ensure the equipment is turned off and it can't be turned on without permission, this ensures the electricians will work safely because there won't be electricity running in the equipment.

    I hope you find this information useful and interesting! Good luck!
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Electrical circuits must be locked-out/tagged-out before electricians work on any equipment. Is this true or false? ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Which of Blender's editors is used to edit an animation's F-Curves? A. The Graph Editor B. The Timeline editor C. The Properties editor D. The Outliner
Answers (1)
Water flows steadily through a section of piping in a heat exchanger at a constant pressure of 1.5 bar, entering as a vapor and exiting as a liquid.
Answers (1)
What is energy in general?
Answers (2)
The function f determines the cost (in dollars) of a new Honda Accord in terms of the number of years t since 2000. That is, f (t) represents the cost (in dollars) of a new Honda Accord t years after 2000.
Answers (2)
When using the separatory funnel; which of the following are important Group of answer choices Shake vigorously to emulsify the two layers. The aqueous layer is always on the bottom. Use a ring clamp to hold the separatory funnel. Vent several times.
Answers (1)
New Questions in Engineering
2. Controlled-access highways permit traffic to enter them only from interchanges. * True False
Answers (1)
Find the apparent gas constant of an ideal gas mixture consisting of 2 kmol of N2 and 4 kmol of CO2
Answers (1)
Why do you think the Combination Square is better to use than the tape measure for making precise measurements?
Answers (1)
What is the purpose of the transformer
Answers (1)
An electric heater draws 12 A from a 120 V power source. How much powe heater dissipate? (a) 10 W (b) 1200 W (c) 1440 W (d) 17,280 W
Answers (1)
Home » Engineering » Electrical circuits must be locked-out/tagged-out before electricians work on any equipment. Is this true or false?
Sign Up Forgot Password?