A ring-shaped seal, made from a viscoelastic material, is used to seal a joint between two rigid pipes. When incorporated in the joint, the seal is held at a xed compressive strain of 0.2. Assuming that the seal can be treated as a Maxwell model, determine the time before the seal begins to leak under and internal uid pressure of 0.3 MPa. It can be assumed that the relaxation time 0 of the material is 300 days and the short-term (instantaneous) modulus of the material is 3 MPa.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “A ring-shaped seal, made from a viscoelastic material, is used to seal a joint between two rigid pipes. When incorporated in the joint, the ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Given the following access-control list: access-list 90 deny 10.168.7.0 0.0.0.255 access-list 90 permit host 10.168.7.10 access-list 90 permit host 10.168.7.11 access-list 90 permit host 10.168.7.
Answers (1)
In a given rocket engine, a mass flow of propellants equal to 87.6 lbm/s is pumped into the combustion chamber, where the stagnation temperature after combustion is 6000°R.
Answers (1)
Which renewable sources are growing at the fastest rate? Which renewable source is used to produce most electricity?
Answers (2)
Classify the terms as related to a thermal system or mechanical system. Conduction, Motion, Distance, Temperature, Absolute Zero, and Speed.
Answers (1)
g An analog voice signal, sampled at the rate of 8 kHz (8000 samples/second), is to be transmitted by using binary frequency shift keying (FSK). The modulator uses two frequencies 1 MHz and 1.2 MHz for signaling the logical bit values 0 and 1.
Answers (1)
New Questions in Engineering
A person with a Class C drivers license may operate
Answers (1)
A conducting spherical shell having an inner radius of 3 cm and outer radius of 4.3 cm carries a net charge of 9.6 μC. A conducting sphere is placed at the center of this shell hav - ing a radius of 0.8 cm and carries a net charge of 1.7 μC.
Answers (1)
Rubber bushings are used on suspensions to A. separate parts B. permit necessary movement C. cushion parts and reduce vibration and noise D. All of the above
Answers (1)
Consider five wireless stations A, B, C, D, E. Station A can communicate with all other stations. B can communicate with A, C, E. C can communicate with A, B, D, and D can communicate with A, C, E. Also E can communicate with A, D, B.
Answers (2)
tech A says that a Hall-effect sensor can be used in an electronic ignition system. Tech B says that an optical-type sensor can be used in an electronic ignition system. Who is correct
Answers (1)