Why is it important that ironworkers wait to begin work until after cement masons are finished with their job?
Cement is an important component of iron.
For most buildings, iron is used to encase the cement.
Constructing a building's framework requires a solid foundation
It is easier for cement masons to correct errors in their work than it is for ironworkers
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Why is it important that ironworkers wait to begin work until after cement masons are finished with their job? Cement is an important ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
In terms of the total cost ("levelized cost") per kiloWatt-hour, which of the following is the cheapest way to provide electrical energy? (a) wind power (b) geothermal power (c) solar panels on the roofs of houses (d) nuclear power
Answers (1)
The correct statement about the relation between the shear stress (force) at the surface for laminar and turbulent flow over a flat plate is. a. The laminar shear stress is greater because the fluid viscosity is not important in turbulent flow. b.
Answers (1)
Determine the flow velocities at the inlet and exit sections of an inclined tapering pipe using fluid flow theory and given pressure readings and flow rates. There is a sloping pipeline that has one end 1.35 m higher than the other.
Answers (1)
The water behind Hoover Dam is 206m higher than the Colorado river below it. At what rate must water pass through the hydraulic turbines of this dam to produce 100 MW of power if the turbines are 100 percent efficient?
Answers (2)
A rigid tank contains 1 kg of oxygen (O2) at p1 = 35 bar, T1 = 180 K. The gas is cooled until the temperature drops to 150 K. Determine the volume of the tank, in m3, and the final pressure, in bar, using the: (a) ideal gas equation of state.
Answers (1)
New Questions in Engineering
A steel with 1.0 % carbon is known as which one of the following: (a) eutectoid, (b) hypoeutectoid, (c) hypereutectoid, or (d) wrought iron?
Answers (1)
A transistor can not be used as a Select one variable resistor switching device regulator tuning device
Answers (1)
Where might you find recommendation engines at work?
Answers (1)
Just getting to your class is enough for showing up. A) True B) False
Answers (2)
A completely reversible heat pump produces heat at a rate of 100 kW to warm a house maintained at 25℃. The exterior air, which is at 0℃, serves as the source.
Answers (1)