The five Human Factors which contribute to lab safety are?
a. Skill, Knowledge, Freedom, Physical Ability, and Ignorance.
b Knowledge, Skill, Attitude, Ignorance, and Environment
C. Skill Physical Ability, Attitude, Environment, and Supervision.
d. Skill, Knowledge, Physical Ability, Attitude, and Supervision.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “The five Human Factors which contribute to lab safety are? a. Skill, Knowledge, Freedom, Physical Ability, and Ignorance. b Knowledge, ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Which of these is not applicable to tuning for some Overshoot on Start-up? Select one: 1) - No overshoot during normal modulating control only 2) - KC-0.2 KU 3) - KC 0.33 KU 4) - KC 0.59 KU 5) - KC-0.78 KU
Answers (1)
Consider an electric motor with a shaft power output of 20 kW and an efficiency of 88 percent. Determine the rate at which the motor dissipates heat to the room it is in when the motor operates at full load.
Answers (1)
You're trying to lift a 298 pound object with a first class lever. You're pushing down on one side of the lever 9ft from the fulcrum, and the object is on the other side 2 ft from the fulcrum.
Answers (1)
A very long pipe of 0.05 m (r1) radius and 0.03 m thickness (r2 - r1) is buried at a depth of 2m (z) to transport liquid nitrogen. The top surface of the ground is flat and has a uniform temperature.
Answers (1)
You are considering the purchase of a heat pump system with aresistive heating element in the air-handler for back-up during the extra cold winter months when the temperature is below the heat pump's capability.
Answers (1)
New Questions in Engineering
The velocity profile for a thin film of a Newtonian fluid that is confined between the plate and a fixed surface is defined by u = (5y-0.5y2) mm/s where y is in mm. Determine the force P that must be applied to the plate to cause this motion.
Answers (1)
The line voltage of a balanced three-phase transmission line is 4200 V rms. The transmission line has an impedance of 4 6 Z j l    per phase. Assuming that the load receives a total of 1 MVA at 0.
Answers (1)
Soap is a very interesting chemical. We even discussed it on the discussion board. How does it work, exactly?
Answers (1)
A steel with 1.0 % carbon is known as which one of the following: (a) eutectoid, (b) hypoeutectoid, (c) hypereutectoid, or (d) wrought iron?
Answers (1)
A transistor can not be used as a Select one variable resistor switching device regulator tuning device
Answers (1)