A gardener is using a 60N wheelbrow to carry 250Nb bag. The force exerted to each handle by gardener is 42 N, The force and the moment at the wheels are respectivelty:
a. Fy=-226 N, M=25 N. m
b. Fy=84 N, M=0
c. FX=100 N, M = 226 N. m
d. Fy=226N, M=0 N. m
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “A gardener is using a 60N wheelbrow to carry 250Nb bag. The force exerted to each handle by gardener is 42 N, The force and the moment at ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Refrigerant-134a enters a 28-cm-diameter pipe steadily at 200 kPa and 20°C with a velocity of 5.5 m/s. The refrigerant gains heat as it flows and leaves the pipe at 180 kPa and 40°C. The specific volumes of R-134a at the inlet and exit are 0.
Answers (1)
This code initially states that n=10 and f=n. Once the code enters the while loop, it stays in the while loop until the condition n>1 is not true. n is subtracted by 1 every iteration. This means that f = 10*9*8*7*6*4*3*2*1.
Answers (1)
An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, materials, and finishes of a component.
Answers (1)
In Florida the fine for going over 5 mph in a school zone results in a fine of how much
Answers (2)
Define a heat engine. Define the efficiency of a heat engine.
Answers (1)
New Questions in Engineering
List two types of inferred values used to indicate level measurements
Answers (1)
Yo can someone find me an e-boy?
Answers (1)
If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile
Answers (1)
A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.
Answers (1)
What design advantages can you identify in the location of the controller
Answers (1)