An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, materials, and finishes of a component. (C) materials, finishes, machining operations, and dimensions of a component. (D) cost, materials, tolerances, and lead-time for a component. (E) cost, dimensions, and machining operations for a component.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
How much time does it take a freezer to make a tray of ice cubes out of a tray of 0.25kg liquid water at 10 Celsius). Assume the freezer is a constant cycle operating between-8 (Celsius) and 35 (Celsius) with a power requirement of 750 N.
Answers (1)
When should you exercise extreme caution around power lines?
Answers (1)
How is every one doing with coronavirus on the loose
Answers (1)
Calculate the length of a metal cylinder while it is subjected to a tensile stress of 10,000 psi. You are given the following dа ta: Original length = 1 in Original cross-sectional area = 0.
Answers (1)
To do a research, a researcher needs to be clear about what he/she is doing, why he/she is doing it and the associated implications of what he/she is about to do. A. True B. False
Answers (1)
New Questions in Engineering
Yo can someone find me an e-boy?
Answers (1)
If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile
Answers (1)
A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.
Answers (1)
What design advantages can you identify in the location of the controller
Answers (1)
A dam 75 ft wide, with a nominal flow rate of 260 ft3/s, is to be studied with a scale model 3 ft wide, using Froude scaling as the most important similarity parameter.
Answers (1)