Engineering

Aydan

1 April, 19:00

Lot ABCD between two parallel street lines is 350.00 ft deep and has a 220.00-ft frontage (AB) on one street and a 260.00-ft frontage (CD) on the other. Interior angles at A and B are equal, as are those at C and D. What distances AE and BF should be laid off by a surveyor to divide the lot into two equal areas by means of a line EF parallel to AB?

+5

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question ✅ “Lot ABCD between two parallel street lines is 350.00 ft deep and has a 220.00-ft frontage (AB) on one street and a 260.00-ft frontage (CD) ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.

Search for Other Answers

You Might be Interested in

Define the difference between yield stress and proof stress

A thermocouple element when taken from a liquid at 50°C and plunged into a liquid at 100° C at time t = 0 gave the following e. m. f. values. Determine the 95% response time. Use linear interpolation inside the intervals

Jeremih pegues sometimes

How can you tell that you're driving in the right direction

What is an environmental purpose of providing hunting licenses

New Questions in Engineering

A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.

What design advantages can you identify in the location of the controller

A dam 75 ft wide, with a nominal flow rate of 260 ft3/s, is to be studied with a scale model 3 ft wide, using Froude scaling as the most important similarity parameter.

The primary heat transfer mechanism that quickly warms my hand if I hold it directly above a campfire is: a) - Radiation b) - Inductance c) - Convection d) - Conduction

A long thin copper rod (K = 377 W/m K) 10 mm in diameter is exposed to an environment at 22 oC. The base temperature of the rod is maintained at 150 oC. The heat transfer coefficient between the rod and the environment is 11 W/m2 K.