How does an accelerometer work?

Water at 15°C is to be discharged from a reservoir at a rate of 18 L/s using two horizontal cast iron pipes connected in series and a pump between them.

2. Determine the surface area of a primary settling tank sized to handle a maximum hourly flow of 0.570 m3/s at an overflow rate of 60.0 m/d. If the effective tank depth is 3.0 m, what is the effective theoretical detention time

A worker is asked to move 30 boxes from a desk onto a shelf within 3 minutes (assume there is enough space and no other lifting work within 8 hours). The shelf height is 55 inches, and the desk height is 30 inches.

Increase the sampling time by a factor of 10 (to 0.1 seconds), keeping the frequency of the square wave the same, and observe the delay. Discuss relationship between sampling time and delay from one board to another.

Which of the following is not a responsibility of a fire watch? Maintain fire extinguishing equipment on-hand and be trained in its use. Be familiar with facility alarms and procedures in the event of a fire.

Primary Creep: slope (creep rate) decreases with time

List two types of inferred values used to indicate level measurements

Yo can someone find me an e-boy?

If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile

A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.