Ask Question
4 July, 22:03

The flow rate of liquid metal into the downsprue of a mold is 500 cm3/s. The cross-sectional area at the top of the sprue is 8 cm2, and the height of the sprue is 15 cm. What should the cross-sectional area be at the base of the sprue in order to avoid separation during pouring of the molten metal

+5
Answers (1)
  1. 4 July, 23:24
    0
    The area at the base should be 2.91cm²

    Explanation:

    The separation of the molten metal may occur when the pressure of the flowing liquid falls below the atmospheric pressure and the air entrapped inside the mold tries to escape but rather gets rapped inside the casting (which is solidifying) causing the liquid to separate and the casting to be porous.

    The velocity at the bottom of the sprue is written as V = √ (2gh), where g is the acceleration due to gravity and h is the height of the sprue

    V = √ (2 x 9.81 x 100 x 15) = 171.6 cm² (Multiplying by 100 to convert 9.81 m/s to cm/s)

    The expression for flow rate is Q = VA where V is the velocity as calculated above and A is the area

    500 = 171.6 x A, solving for A we get A = 500/171.6 = 2.91cm²

    The cross - sectional Area at the base of the sprue should be 2.91cm² to avoid separation of the molten metal.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “The flow rate of liquid metal into the downsprue of a mold is 500 cm3/s. The cross-sectional area at the top of the sprue is 8 cm2, and the ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers