Elastic recovery: a. Is the strain that remains in a material when it is deformed plastically, then unloaded. b. Is the strain that occurs when a material is loaded elastically, then unloaded. c. Is the difference between the strain right before unloading and the strain that remains after unloading. d. None of the above.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Elastic recovery: a. Is the strain that remains in a material when it is deformed plastically, then unloaded. b. Is the strain that occurs ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Which one of the following is not a possible output device for an ECM? (A) radiator fan relay (B) fuel pump relay (C) ignition module (D) EGR solen (E) transmission control solenoid (F) throttle position variable resistor (G) ignition coils (H) air
Answers (1)
Rewrite the following nested if-else statement as a switch statement that accomplishes exactly the same thing. Assume that num is an integer variable that has been initialized, and that there are functions f1, f2, f3, and f4.
Answers (1)
List 3 types of heat exchangers, and classify them?
Answers (1)
Two previously undeformed cylindrical specimens of an alloy are to be strain hardened by reducing their cross-sectional areas (while maintaining their circular cross sections).
Answers (1)
5. A non-cold-worked brass specimen of average grain size 0.01 mm has a yield strength of 150 MPa. Estimate the yield strength of this alloy after it has been heated to 500°C for 1000 s, if it is known that the value of σ0 is 25 MPa.
Answers (1)
New Questions in Engineering
Convert 30.12345 degrees into degrees, minutes and seconds.
Answers (1)
Between a hypothesis and a prediction
Answers (1)
A local reaction is when a chemical enters the bloodstream?
Answers (1)
The rules for ordinary arithmetic involving addition, subtraction, and multiplication carry over into modular arithmetic. Tru
Answers (1)
An air-conditioning system is used to maintain a house at 70°F when the temperature outside is 100°F. The house is gaining heat through the walls and the windows at a rate of 800 Btu/min, and the heat generation rate within the house from people,
Answers (2)