Ask Question
EngineeringEngineering
5 July, 01:43

What steel type and ASTM designation is preferred for W-shapes?

+4
Answers (1)
  1. 5 July, 04:29
    0
    The preferred steel type for W-shapes is structural steel and the its preferred ASTM designation is ASTM A992.

    Explanation:

    The ASTM A992 is a structural steel and it's the most available for w-shapes; besides its availabilty, its ductility improvements makes it the preferred choice; other common designations for this shapes are ASTM A572 Grade 50,0r ASTM A36, but this designations aren't as available as ASTM A992, and it has to be confirmed prior to their specification.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “What steel type and ASTM designation is preferred for W-shapes? ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Codes of ethics state the engineer's duties to society, to employers, to clients, to colleagues, to subordinates, and to the profession. However, when these duties conflict, which group should take precedence? a. Employers and clients b.
Answers (1)
A system that is not influence anyway by the surroundings is called a) - control mass system b) - Isothermal system c) - - isolated system d) - open system
Answers (1)
A two-dimensional reducing bend has a linear velocity profile at section (1). The flow is uniform at sections (2) and (3). The fluid is incompressible and the flow is steady. Find the maximum velocity, V1, max, at section (1).
Answers (1)
Unwanted resistance is being discussed. Technician A says that unwanted resistance can be caused by a loose ground connectic Technician B says that unwanted resistance can be caused by corrosion at a connectior Who is correct? a. Technician A c.
Answers (1)
Fresh cut potato strips with a moisture content of 50% (w/w) on wet basis are fried in peanut oil to produce French fries.
Answers (1)
New Questions in Engineering
What minimum radius of curvature may be designed for safe operation of vehicles at 70 mi/hr if the maximum rate of superelevation (e) is 6% and the maximum coefficient of side friction (f) is 0.10?
Answers (1)
Determine the temperature, in K, of 5 kg of air at a pressure of 0.3 MPa and a volume of 2.2 m3. Ideal gas behavior can be assumed for air under these conditions.
Answers (1)
2. What is an important aspect of the American free enterprise system that encourages people to improve their material well-being? (profit motive)
Answers (2)
It is suggested that the kitchen in your house could be cooled in the summer by closing the kitched from the rest of the house and opening the door to the domestic electric refrigerator. Is it true or false? State the reason for your conclusion.
Answers (1)
True or false Make sure all guard are in place and working at all times
Answers (1)
Home » Engineering » What steel type and ASTM designation is preferred for W-shapes?
Sign Up Forgot Password?