Sign In
Ask Question
Engineering
Rey Meza
3 March, 13:17
What are wheel cylinders used for?
+2
Answers (
1
)
Biffle
3 March, 16:45
0
A hydraulic brake system
Explanation:
A wheel cylinder is a component of a hydraulic brake system. It is located in each wheel and is usually positioned at the top of the wheel, above the shoes. Its function is to exert force onto the shoes so as to bring them into contact with the drum and stop the vehicle with friction.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Find an answer to your question ✅
“What are wheel cylinders used for? ...”
in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
You are ordering steel cable for a 250 foot long zip-line you are building in your back yard. The cable can be ordered in diameters with 1/16 inch increments. (1/16, 1/8, 3/16, 1/4, 5/16, 3/8, etc.
Answers (2)
If the head loss in a 30 m of length of a 75-mm-diameter pipe is 7.6 m for a given flow rate of water, what is the total drag force exerted by the water on this length of pipe?
Answers (1)
When in a flow do the streamlines, streak lines and timelines coincide?
Answers (1)
A computer chip inside an orbiting satellite heats up during operation. Since there is no air in the satellite the only cooling will be by radiation. The chip is 1.50 cm wide by 2.50 cm long with a negligible thickness; it has an emissivity of 0.
Answers (1)
How does the engine's crankshaft transmit energy to an automatic transmission? Group of answer choices Through the clutch Through the throw-out bearing Through the flex plate None of the answers listed
Answers (1)
New Questions in Engineering
Yo can someone find me an e-boy?
Answers (1)
If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile
Answers (1)
A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.
Answers (1)
What design advantages can you identify in the location of the controller
Answers (1)
A dam 75 ft wide, with a nominal flow rate of 260 ft3/s, is to be studied with a scale model 3 ft wide, using Froude scaling as the most important similarity parameter.
Answers (1)
Home
»
Engineering
» What are wheel cylinders used for?
Sign In
Sign Up
Forgot Password?