Engineering

Gauge Cox

21 June, 22:07

A capillary tube is immersed vertically in a water container. Knowing that water starts to evaporate when the pressure drops below 2 kPa, determine the maximum capillary rise and tube diameter for this maximum-rise case. Take the contact angle at the inner wall of the tube to be 6° and the surface tension to be 1.00 N/m.

+4

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question ✅ “A capillary tube is immersed vertically in a water container. Knowing that water starts to evaporate when the pressure drops below 2 kPa, ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.

Search for Other Answers

You Might be Interested in

If you should lose your balance, you should grab onto the turning center to steady yourself.

What is the function of engineers?

Kirchhoff's junction law says that the total current into a junction must equal the total current leaving the junction. a. True b. False

Write multiple if statements: If carYear is before 1968, print "Probably has few safety features." (without quotes). If after 1971, print "Probably has head rests.". If after 1991, print "Probably has anti-lock brakes.".

The alignment readings for the front of a vehicle are shown above. Camber and toe are within specification, caster is not. Technician A says that with the current settings, the left front tire tread may wear on the inside edge.

New Questions in Engineering

Primary Creep: slope (creep rate) decreases with time

List two types of inferred values used to indicate level measurements

Yo can someone find me an e-boy?

If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile

A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.