In a surface grinding operation, the wheel diameter = 8.0 in, wheel width = 1.0 in, wheel speed = 6000 ft/min, work speed = 40 ft/min, infeed = 0.002 in, and crossfeed = 0.20 in. The number of active grits per square inch of wheel surface = 400. Determine
(a) the average length per chip,
(b) the metal removal rate
(c) the number of chips formed per unit and the average volume per chip?
(d) If the tangential cutting force on the workpiece is 50 lb, what is the specific energy calculated for this job?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “In a surface grinding operation, the wheel diameter = 8.0 in, wheel width = 1.0 in, wheel speed = 6000 ft/min, work speed = 40 ft/min, ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
A ball bearing has been selected with the bore size specified in the catalog as 35.000 mm to 35.020 mm. Specify appropriate minimum and maximum shaft diameters to provide a locational interference fit.
Answers (1)
Suppose there is exactly one packet switch between a sending host and a receiving host. The transmission rates between the sending host and the switch and between the switch and the receiving host are R1 and R2, respectively.
Answers (1)
Why is my dog barking?
Answers (2)
Se requiere un permiso aprobación o restricción contaminante para todos los métodos comerciales de descarga de aguas residuales?
Answers (1)
Technician A says that hot spots on the flywheel are a result of excessive heat. Technician B says that a pulsation in a clutch pedal could be due to uneven clutch pressure plate levers. Who is correct?
Answers (1)
New Questions in Engineering
Just getting to your class is enough for showing up. A) True B) False
Answers (2)
A completely reversible heat pump produces heat at a rate of 100 kW to warm a house maintained at 25℃. The exterior air, which is at 0℃, serves as the source.
Answers (1)
A closed system undergoes a process in which work is done on the system and the heat transfer Q occurs only at temperature Tb. For each case, determine whether the entropy change of the system is positive, negative, zero, or indeterminate.
Answers (1)
A scientist who is evaluating an ancient human skeleton for signs of vitamin and nutrient deficiency is conducting:
Answers (1)
Which of the following is required in order to make a protected left turn A. A left green arrow B. No oncoming traffic C. A left turn only lane D. A large enough gap
Answers (1)