I want to delete my account

Refrigerant-134a enters a 28-cm-diameter pipe steadily at 200 kPa and 20°C with a velocity of 5.5 m/s. The refrigerant gains heat as it flows and leaves the pipe at 180 kPa and 40°C. The specific volumes of R-134a at the inlet and exit are 0.

This code initially states that n=10 and f=n. Once the code enters the while loop, it stays in the while loop until the condition n>1 is not true. n is subtracted by 1 every iteration. This means that f = 10*9*8*7*6*4*3*2*1.

An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, materials, and finishes of a component.

In Florida the fine for going over 5 mph in a school zone results in a fine of how much

Define a heat engine. Define the efficiency of a heat engine.

List two types of inferred values used to indicate level measurements

Yo can someone find me an e-boy?

If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile

A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.

What design advantages can you identify in the location of the controller