Which of the following components of a PID controlled accumulates the error over time and responds to system error after the error has been accumulated? a) - Proportional b) - Derivative c) - Integral d) - ON/OFF.

2.18 The net potential energy between two adjacent ions, EN, may be represented by the following equation: (1) Calculate the bonding energy E0 in terms of the parameters A, B, and n using the following procedure: 1.

I have a resistor connected to a power supply that delivers a fixed voltage for any current (up to some maximum current). With a multimeter, I find that the resistance of the resistor is 50 Ohm resistor and that the current flowing through it is 0.

Carbon fiber is made up of extraordinarily thin filaments - about one hundredth the thickness of a human hair. 1) True 2) False

8. What side length would you specify if you were required to create a regular hexagonal plate that was comprised of 33 cm - of sheet metal? Bonus: Sketch the hexagon, dimension the side length on the sketch to 0.1 cm, and indicate your grid spacing.

A flywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. Determine the total number of revolutions of the flywheel during the period of its acceleration. a. 5.65 b. 8.43 c. 723 d. 6.86

List two types of inferred values used to indicate level measurements

Yo can someone find me an e-boy?

If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile

A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.

What design advantages can you identify in the location of the controller