In ARQ, a NAK:
a. is sent by the recipient if the message was received without error
b. is sent by the sender at the same time as it sends a data packet
c. is sent by the recipient if the message contains an error refers to non-asynchronous
d. Kermit technique means that the sender should continue with sending the next message
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “In ARQ, a NAK: a. is sent by the recipient if the message was received without error b. is sent by the sender at the same time as it sends ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Select the correct answer. Which social service is a benefit of transportation? A. production of goods B. connectivity to health care C. regulatory control D. supply of raw materials
Answers (1)
You should maintain a __ following distance behind a vehicle you wish to pass.
Answers (1)
The fouling on the heat exchanger surfaces causes additional thermal resistance, thus decreases the heat transfer rate. a) - True b) - False
Answers (1)
A flame ionization detector, which is often used in gas chromatography, responds to a change in a.) collection of electrons within a flame b.) absorption within a flame c.) emission within a flame d.) the resistance of a heated wire
Answers (1)
At steady state, a reversible heat pump cycle discharges energy at the rate to a hot reservoir at temperature TH, while receiving energy at the rate from a cold reservoir at temperature TC.
Answers (1)
New Questions in Engineering
List two types of inferred values used to indicate level measurements
Answers (1)
Yo can someone find me an e-boy?
Answers (1)
If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile
Answers (1)
A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.
Answers (1)
What design advantages can you identify in the location of the controller
Answers (1)