Which of the following quenching materials is LEAST severe in its quenching action (slowest cooling) ? a. Air b. Brine c. Oil d. Water
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Which of the following quenching materials is LEAST severe in its quenching action (slowest cooling) ? a. Air b. Brine c. Oil d. Water ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
The ducts of an air heating system pass through an unheated area. As a result of heat losses, the temperature of the air in the duct drops by 4°C.
Answers (1)
Which of these actions can be taken to minimize number of victims or prevent injury? (check all that apply) A. Hire good lawyers to defend those responsible for the disater. B. Regular inspections of man-made structures by licensed inspectors. C.
Answers (1)
A digital-to-analog converter uses a reference voltage of 120 V dc and has eight binary digit precision. In one of the sampling instants, the data contained in the binary register = 01010101.
Answers (2)
The intercept of the CML is the origin while the intercept of the SML is RF CML consists of efficient portfolios, while the SML is concerned with all portfolios or securities CML could be downward sloping while that is impossible for the SML CML and
Answers (1)
A roller support acts like a contact boundary condition as it can produce a reaction force as a push response to a body but will not produce a pull force to hold a body from moving away. a) True b) - False
Answers (1)
New Questions in Engineering
Primary Creep: slope (creep rate) decreases with time
Answers (1)
List two types of inferred values used to indicate level measurements
Answers (1)
Yo can someone find me an e-boy?
Answers (1)
If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile
Answers (1)
A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.
Answers (1)