A 35-pound force is applied to a 3-inch cylinder with a 6-inch stroke. What is the power produced by the cylinder that moves its full stroke in 0.7 s?

Describe your experience in using command-line utilities instead of GUI utilities for network configuration - which do you prefer and why, plus the benefit of each. Describe any utilities you are familiar with.

Which of the following would require the filing of an EIS? a. expansion of an airport in a national park b. allowing snowmobiles in a national park c. erecting a research telescope facility in a national park d. All of the above would require an EIS.

If a 110-volt appliance requires 20 amps, what is the total power consumed?

A long thin copper rod (K = 377 W/m K) 10 mm in diameter is exposed to an environment at 22 oC. The base temperature of the rod is maintained at 150 oC. The heat transfer coefficient between the rod and the environment is 11 W/m2 K.

What can be said about short circuits?

Yo can someone find me an e-boy?

If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile

A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.

What design advantages can you identify in the location of the controller

A dam 75 ft wide, with a nominal flow rate of 260 ft3/s, is to be studied with a scale model 3 ft wide, using Froude scaling as the most important similarity parameter.