Technician A says a "dry park check" is a good way to check ball joints and control arm bushings for looseness. Technician B says that inner tie rod ends
can be most effectively checked for wear on an alignment rack with the vehicle's weight on the wheels and the locking pins removed from the turn
plates. Who is correct?
A. Technician A only
B. Technician B only
C. Both Technician A and B
D. Neither Technician A nor B
Answers (2)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Technician A says a "dry park check" is a good way to check ball joints and control arm bushings for looseness. Technician B says that ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Suppose you have two boxes in front of you. One box contains a Thevenin Equivalent (voltage source in series with a resistor) and the other box contains a Norton Equivalent (current source in parallel with a resistor).
Answers (1)
If the outside diameter of a pipe is 2 m, the length of a piece of insulation wrapped around it would be a) - 628 cm b) - 12.56 m. c) - 12.56 cm d) - 62.8 m
Answers (1)
How is the fuel introduced into the Diesel engine?
Answers (1)
How can you tell if your car is overheating? A. Your temperature gauge is moving into the red or "H" zone. B. Your temperature gauge is moving into the blue or "C" zone. C. You physically feel your car is getting hot. D.
Answers (1)
1. The AWS A5.5 is a list of electrodes used to weld which type of metal? A Copper and copper alloys. B. Carbon steels. C. Low alloy steels. D. Gray and ductile iron. E. Corrosion-resistant steels.
Answers (1)
New Questions in Engineering
Yo can someone find me an e-boy?
Answers (1)
If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile
Answers (1)
A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.
Answers (1)
What design advantages can you identify in the location of the controller
Answers (1)
A dam 75 ft wide, with a nominal flow rate of 260 ft3/s, is to be studied with a scale model 3 ft wide, using Froude scaling as the most important similarity parameter.
Answers (1)