Which statement describes a third class lever?
The fulcrum is between the input and output forces.
The input force is between the fulcrum and output force.
The input and output forces are equal distance from the fulcrum.
The output force is between the fulcrum and input force.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Which statement describes a third class lever? The fulcrum is between the input and output forces. The input force is between the fulcrum ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
In poor weather you shpuld___ your following distance
Answers (2)
Two identical, insulated pistons and cylinders each contain 10 moles of the same gas. The gases initially are at the same temperature and 2 bar pressure. They are both compressed to one-tenth of their original volumes.
Answers (1)
A balanced three phase load is supplied over a three-phase, 60 hz, transmission line with each line have a series impedance of (12.84 j72.76) ohms, the load voltage is 132 kV and the load power is 55 MVA at 0.8 lagging power factor. Determine: a.
Answers (1)
A structural component is fabricated from an alloy that has a plane-strain fracture toughness of 62 MPa√m. It has been determined that this component fails at a stress of 250 MPa when the maximum length of an internal crack is 1.6 mm.
Answers (1)
If you dig a six foot hole how many feet of dirt are in it
Answers (2)
New Questions in Engineering
What is the distance 1
Answers (1)
Convert 30.12345 degrees into degrees, minutes and seconds.
Answers (1)
Between a hypothesis and a prediction
Answers (1)
A local reaction is when a chemical enters the bloodstream?
Answers (1)
The rules for ordinary arithmetic involving addition, subtraction, and multiplication carry over into modular arithmetic. Tru
Answers (1)