Engineering » Page 31

Engineering

Brynn Valdez

What is the advantage to use a multistage compression refrigeration system over a single stage compression system?

Answer Answers (1)

Engineering

Conner Mullen

Suppose there is exactly one packet switch between a sending host and a receiving host. The transmission rates between the sending host and the switch and between the switch and the receiving host are R1 and R2, respectively. Assuming that the switch uses store-and-forward packet switching, what is the total end-to-end delay to send a packet of length L?

Answer Answers (1)

Engineering

Kadin Rowe

The primary difference between integrated/concurrent engineering development and functional/sequential development is: Integrated development spends more money up front to order to save money in later stages. Sequential development is more thorough in addressing development steps. In sequential development, multiple functions co-manage design and testing. Integrated development usually leads to higher sustaining and warranty costs.

Answer Answers (1)

Engineering

Aimee Hogan

Question 7.1: Two possible overhead valve combustion chambers are being considered - the first has two valves; the second has four valves per cylinder. The diameter of the inlet valve is 23 mm for the first design and 18.5 mm for the second design. If the second design is adopted, show that the total valve perimeter is increased by 60.8%. If the valve lift is restricted to the same fraction of valve diameter, calculate the increase in flow area. What are the additional benefits in using 4 valves per cylinder?

Answer Answers (1)

Engineering

Jayleen Gregory

Work done by a system during a process can be considered as a property of the system. a) True b) False

Answer Answers (1)

Engineering

Miracle Gordon

Difference between a pillar drill and radial arm pillar

drill

Answer Answers (1)

Engineering

Rodolfo Nash

Which of the following should you do if your accelerator is stuck?

Answer Answers (1)

Engineering

Guest

The surface energy of a single crystal depends on crystallographic orientation. Does this surface energy increase or decrease with an increase in planar density? Why?

Answer Answers (1)

Engineering

Xiomara Keith

A dog-bone test sample with an area of. 235 in2 is subjected to a force of 4,000 lbs. Which of the following could be calculated based on this information?

A.) Strain

B.) Modulus of Elasticity

C.) Change in volume

D.) Stress

Answer Answers (1)

Engineering

Joel Finley

The primary heat transfer mechanism that sears my skin if I fall in a campfire is: a) - Syncrotonization b) - Radiation c) - Conduction d) - Convection

Answer Answers (1)

Engineering

Moocher

An electric motor under steady load draws 9.7 amperes at 110 volts; it delivers 1.25 (hp) of mechanical energy. The temperature of the surroundings is 300 K. What is the total rate of entropy generation in W·K-1?

Answer Answers (1)

Engineering

Haleigh Booker

Fin efficiency is defined in relation to the maximum possible heat transfer rate from the fin for given convective conditions. This maximum possible heat transfer rate is defined on the basis that: The fin has a uniform temperature equal to that of its base The convection heat transfer coefficient is infinite The fin has zero thermal conductivity The fin has a uniform temperature equal to that of the surrounding air The fin is infinitely long

Answer Answers (1)

Engineering

Mercedes Macias

When fire extinguishers are available for employee use, it is the employer's responsibility to educate employees on the principles and practices of using a fire extinguisher and the hazards associated with fighting small or developing fires.

A:True

B:False

Answer Answers (2)

Engineering

Joey

What is the term for removing refrigerant in any condition from a system and storing it in an external container without necessarily testing for processing it in any way

Answer Answers (1)

Engineering

Abdullah Mayo

28. List the 3 basic parts of a lamp?

Answer Answers (2)