Ask Question
2 May, 21:42

witch type of plate boundary does san andreas fault represent

+4
Answers (2)
  1. 3 May, 00:18
    0
    There are 3 primary types of Tectonic Plate boundaries: Divergent boundaries; Covergent boundaries; and Transform boundaries.

    The San Andreas Fault, I believe, falls into the latter category.

    Transform-Fault Boundaries: Transform-Fault Boundaries are where two plates are sliding horizontally past one another. These are also known as transform boundaries or more commonly as faults.

    Most transform faults are found on the ocean floor. They commonly offset active spreading ridges, producing zig-zag plate margins, and are generally defined by shallow earthquakes. A few, however, occur on land. The San Andreas fault zone in California is a transform fault that connects the East Pacific Rise, a divergent boundary to the south, with the South Gorda - - Juan de Fuca - - Explorer Ridge, another divergent boundary to the north. The San Andreas is one of the few transform faults exposed on land. The San Andreas fault zone, which is about 1,300 km long and in places tens of kilometers wide, slices through two thirds of the length of California. Along it, the Pacific Plate has been grinding horizontally past the North American Plate for 10 million years, at an average rate of about 5 cm/yr. Land on the west side of the fault zone (on the Pacific Plate) is moving in a northwesterly direction relative to the land on the east side of the fault zone (on the North American Plate).
  2. 3 May, 00:39
    0
    The convergent plate boundary
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “witch type of plate boundary does san andreas fault represent ...” in 📘 English if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers