Ask Question
7 March, 14:30

What feature of a DMM allows you to connect the test probes in the circuit, remove the probes, and then read the measured value on the display?

A. Diode tester

B. Minimum/maximum feature

C. Delta feature

D. Touch/hold feature

Which direction do electrons travel?

A. They don't move; they simply exchange charge.

B. In either direction, depending on the circuit

C. From positive to negative

D. From negative to positive

A circuit contains a 40 ohm resistor and a 60 ohms resistor connected in parallel. If you test this circuit with a DMM, you should read a total resistance value of

A. 40 ohms.

B. 24 ohms.

C. 2400 ohms.

D. 2.5 ohms

+5
Answers (1)
  1. 7 March, 15:29
    0
    B. 24 ohms. D. Touch/hold feature

    D. From negative to positive = negative charges

    B. 24 ohms.

    in parallel, combined resistance is less than the lowest resistance
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “What feature of a DMM allows you to connect the test probes in the circuit, remove the probes, and then read the measured value on the ...” in 📘 Physics if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers