An overhang hollow shaft carries a 900 mm diameter pulley, whose centre is 250 mm from the centre of the nearest bearing. The weight of the pulley is 600 N and the angle of lap is 180°. The pulley is driven by a motor vertically below it. If permissible tension in the belt is 2650 N and if coefficient of friction between the belt and pulley surface is 0.3, estimate, diameters of shaft, when the internal diameter is 0.6 of the external. Neglect centrifugal tension and assume permissible tensile and shear stresses in the shaft as 84 MPa and 68 MPa respectively.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “An overhang hollow shaft carries a 900 mm diameter pulley, whose centre is 250 mm from the centre of the nearest bearing. The weight of the ...” in 📘 Physics if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
Which is not a vector quantity? a. displacement b. velocity c. time d. acceleration
Answers (1)
2. Weight is a force from gravity pulling down on any object with mass. True False
Answers (1)
8. There are different characteristics for each of the states of matter. Which statement describes a difference between solids and liquids? a. Temperatures can change a solid to a liquid, but cannot change a liquid to a solid, b.
Answers (1)
A 5 feet tall man went for swimming in a pool. He saw the depth of water in the pool less than 5 feet. Will he be drowned? Write with reason.
Answers (2)
Name at least two limitations of using models in science.
Answers (2)
New Questions in Physics
If a pressure gauge measure an increase in 3*10^ (5) Pa on an area of 0.7 m^2, calculate the increase in the force applied to the area?
Answers (1)
Which of the following is an example of potential rather than kinetic energy? a. water rushing over Niagara Falls b. a molecule of glucose c. a crawling beetle foraging for food d. light flashes emitted by a firefly
Answers (1)
If a force of 15 newtons [N] is applied to a surface and the pressure is measured as 4,000 pascals [Pa], what is the area of the surface in units of square milimeters [mm2 ]?
Answers (2)
An engineer has the task of producing an aluminum alloy with a density of 3.0 grams per cubic centimeter. She comes up with the perfect alloy and saves a sample of it. Which mass and volume measurements correspond to this sample? 7 g and 2.
Answers (1)
What must be your car's average speed in order to travel 235km in 3.25 hours?
Answers (1)