Why does a light go out when you turn off the wall switch?
-The switch absorbs the electrical energy.
-The switch changes the direction of the flow of electrons.
-The switch changes the circuit from series to parallel.
-The switch causes a break in the circuit.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Why does a light go out when you turn off the wall switch? -The switch absorbs the electrical energy. -The switch changes the direction of ...” in 📘 Physics if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
It takes much longer to bake a whole potato than potatoes that have been cut into pieces why?
Answers (1)
An object is dropped and falls freely to the ground with an acceleration of g. If it is thrown upward at an angle instead, its acceleration would be:
Answers (1)
This law states that a planet's elliptical orbit around the Sun sweeps equal amounts of area in an equal amount of time. This means that each planet travels faster near the Sun and slower farther from it. A. law of ellipses B. law of inertia C.
Answers (1)
In the rate of precession were doubled, how would the seasons in the northern hemisphere be affected
Answers (1)
Explain why the Earth is not a perfectly round sphere.
Answers (1)
New Questions in Physics
How does an electromagnetic wave propagate itself? a. A changing magnetic field induces an electric field perpendicular to the magnetic field. b. A changing electric field induces a magnetic field perpendicular to the electric field. c.
Answers (1)
Which of the following is an example of convection? A. hot air rising and cooler air falling B. a hot object transferring heat to a cooler one C. a hot oven warming the air around it D. the rays of the Sun warming the earth
Answers (1)
A 50,000 kg locomotive is traveling at 10 m/s when its engine and brakes both fail. How far will the locomotive roll before it comes to a stop? Assume the track is level.
Answers (1)
A rectangular loop of wire with sides 0.262 and 0.401 m lies in a plane perpendicular to a constant magnetic field (see part a of the drawing). The magnetic field has a magnitude of 0.
Answers (2)
In the system you're inspecting the damper motor isn't working, You decide to see if the damper-postion sensor us sending the proper signal to the which then signals the damper motor. A. heating coil B. duckwork c. energy source D. controller
Answers (1)