What is a good reason to keep a project's file size small?
A.
The file will take longer to export.
B.
The objects in your project will be organized better.
C.
It takes less time to send the file in an e-mail message.
D.
The smaller file will have more old information about your project.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “What is a good reason to keep a project's file size small? A. The file will take longer to export. B. The objects in your project will be ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
What happens to the microstructure during tempering? How does the mechanical properties of the steel change due to tempering? How do you perform tempering? What type of steel is usually tempered?
Answers (1)
Which of the following describes a logic bomb? a rogue piece of code in a system activates on a certain date a piece of code replaces the boot instructions the cookie tracker is exploited to note your browsing habits a piece of code hidden in a
Answers (1)
Hot water (cph = 4188 J/kg·K) with a mass flow rate of 2.5 kg/s at 100°C enters a thin-walled concentric tube counterflow heat exchanger with a surface area of 23 m2 and an overall heat transfer coefficient of 1000 W/m2 ·K.
Answers (1)
A multilane highway (two lanes in each direction) is on level terrain. The free-flow speed has been measured at 45 mi/h. The peak-hour directional traffic flow is 1300 vehicles with 8% heavy vehicles. If the peak-hour factor is 0.
Answers (1)
The Prince Company, Inc has 100 employees. In 2009, the employees worked a total of 350,000 hours annual and reported 145 injuries/illnesses.
Answers (1)
New Questions in Engineering
List two types of inferred values used to indicate level measurements
Answers (1)
Yo can someone find me an e-boy?
Answers (1)
If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile
Answers (1)
A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.
Answers (1)
What design advantages can you identify in the location of the controller
Answers (1)