Engineering

Deandre Vargas

9 April, 02:46

Why are dynamic heads greater than static heads?

1. Because static suction lifts are limited in vertical lift

2. Because the friction losses are always greater than the

static heads

3. Because they are measured on the discharge side of the

pump

4. Because they include the static heads plus the friction

losses in the suction and discharge pipes

+1

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question ✅ “Why are dynamic heads greater than static heads? 1. Because static suction lifts are limited in vertical lift 2. Because the friction ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.

Search for Other Answers

You Might be Interested in

On 38 Which of these is not an implementation of a Failure Mode and Effects Analysis? red ed out of lag Ton Select one: O a. Define and prioritize actions. O b. Identify environmental impacts. c. Identify failure modes. O d.

Describe the process that you would use to hot forge an automotive connecting rod, indicating why each of the steps is used.

tori is planning to buy a car. the maximum payment she can make is $3400 per year, and she can get a car loan at her credit union for 7.3% interest. Assume her payments will be made at the end of each year 1-4.

The performance of a heat pump degrades (i. e., its COP decreases) as the temperature of the heat source decreases. This makes using heat pumps at locations with severe weather conditions unattractive.

In one of her experiments, she used a binary mixture of n-pentane (density 39.1 lbm/ft^3) and p-xylene (density 53.8 lbm/ft^3).

New Questions in Engineering

Primary Creep: slope (creep rate) decreases with time

List two types of inferred values used to indicate level measurements

Yo can someone find me an e-boy?

If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile

A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.