Engineering

Elsa Baldwin

28 June, 14:53

An adiabatic heat exchanger is to cool ethylene glycol (cp = 2.56 kJ/kg ºC) flowing at a rate of 2 kg/s from 80 to 40 ºC by liquid water that enters at 20 ºC and leaves at 55 ºC. Determine:

(a) the rate of heat transfer between the water and the ethylene glycol and

(b) the rate of entropy generation in the heat exchanger

+3

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question ✅ “An adiabatic heat exchanger is to cool ethylene glycol (cp = 2.56 kJ/kg ºC) flowing at a rate of 2 kg/s from 80 to 40 ºC by liquid water ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.

Search for Other Answers

You Might be Interested in

Recrystallization Incorrect. During the recrystallization of a cold-worked material, which of the following statement (s) is (are) true? Some of the internal strain energy is relieved. a.

Increase the sampling time by a factor of 10 (to 0.1 seconds), keeping the frequency of the square wave the same, and observe the delay. Discuss relationship between sampling time and delay from one board to another.

A bicycle travels 12 km in 40 minutes. Its average speed is a. 0.30 km b) 8.0 km/hr c. 18.0 km d. 48.0 km hr

A square-thread power screw has a major diameter of 32 mm and a pitch of 4 mm with single threads, and it is used to raise a load putting a force of 6.5 kN on the screw. The coefficient of friction for both the collar and screw is. 08.

A Capacitor is a circuit component that stores energy and can be charged when current flows through it. A current of 3A flows through a capacitor that has an initial charge of 2μC (micro Coulombs).

New Questions in Engineering

Brian is responsible for ordering cement for a construction project. He had just determined that the construction crew would need 540 cubic yards of cement when the building owner decided to shorten the driveway, eliminating the need for 44 cubic

Dave is a recruiter for a very large graphic design firm and he is looking for an employee who is willing to give the entire productive hours to activities related to the job. Which quality is he looking for?

Which of the following is a common use for commas? Separating two elements Separating unrelated adjectives Connecting two independent clauses Connecting two dependent clauses

Which component stores energy as potential energy in a mechanical system?

A floor system has W24 x 55 sections spaced 8'-0"" o. c. supporting a floor dead load of 50 psf and a live load of 80 psf. Determine the governing load. Show all work.