Ask Question
EngineeringEngineering
26 September, 01:19

Describe the grain structure of a metal ingot that was produced by slow-cooling the metal in a stationary open mold.

+2
Answers (1)
  1. 26 September, 03:21
    0
    Explained

    Explanation:

    In case case of slow cooling of a metal ingot, the micro structure is more like coarse. At the surface due to high heating rate (surface will to exposed to higher temperature than the inner part and for longer time) the grains are small as grains will get lesser time to cool. Where as we go inside the grains will be gradually elongated. At the center we will find equiaxed grains.
Know the Answer?
Not Sure About the Answer?
Find an answer to your question ✅ “Describe the grain structure of a metal ingot that was produced by slow-cooling the metal in a stationary open mold. ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.
Search for Other Answers
You Might be Interested in
is Compression ratio decreased when a large volume of combustion chamber deposits accumulate in the engine?
Answers (1)
A square isothermal chip is of width w = 5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at T[infinity] = 15°C.
Answers (1)
What is the technique used during the activities definition process that breaks down the "work units" in a work package into smaller and smaller chunks to identify what activities are required to complete that "work chunk"?
Answers (1)
The A-36 steel pipe has a 6061-T6 aluminum core. It issubjected to a tensile force of 200 kN. Determine the averagenormal stress in the aluminum and the steel due to thisloading. The pipe has an outer diameter of 80 mm and aninner diameter of 70mm.
Answers (1)
Estimate the power required for this operation at the spindle, needed at the motor, of the motor if there is a 15% loss in the transfer of energy.
Answers (1)
New Questions in Engineering
Just getting to your class is enough for showing up. A) True B) False
Answers (2)
A completely reversible heat pump produces heat at a rate of 100 kW to warm a house maintained at 25℃. The exterior air, which is at 0℃, serves as the source.
Answers (1)
A closed system undergoes a process in which work is done on the system and the heat transfer Q occurs only at temperature Tb. For each case, determine whether the entropy change of the system is positive, negative, zero, or indeterminate.
Answers (1)
A scientist who is evaluating an ancient human skeleton for signs of vitamin and nutrient deficiency is conducting:
Answers (1)
Which of the following is required in order to make a protected left turn A. A left green arrow B. No oncoming traffic C. A left turn only lane D. A large enough gap
Answers (1)
Home » Engineering » Describe the grain structure of a metal ingot that was produced by slow-cooling the metal in a stationary open mold.
Sign Up Forgot Password?