Engineering

Larry Medina

25 September, 17:15

Select the most economical W section of 50ksi steel for a 40 ft simple beam that supports a service concentrated load PL=30k at the midspan is laterally unbraced except at its ends and center line. If the maximum permissible center line deflection is 1/1000 of the span. Neglect beam weight.

+4

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question ✅ “Select the most economical W section of 50ksi steel for a 40 ft simple beam that supports a service concentrated load PL=30k at the midspan ...” in 📘 Engineering if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.

Search for Other Answers

You Might be Interested in

The radiator of a steam heating system has a volume of 35 L and is filled with superheated water vapor at 200 kPa and 200°C. At this moment, both the inlet and the exit valves to the radiator are closed.

Pressurized reservoirs that provide fluid to hydraulic equipment circuits are called A. pneumatic pools B. Accumulators C. Output Actuators D. Confined Pistons

19.11 The atmosphere is stable with a lapse rate of - 0.2 °C/100 m. The surface air temperature is 15 °C. A parcel of air is released at the ground with a temperature of 25 °C. Calculate the maximum mixing height, in m.

The driving force for fluid flow is the pressure difference, and a pump operates by raising the pressure of a fluid (by converting the mechanical shaft work to flow energy). A gasoline pump is measured to consume 3.

How high does receptacles have to be in a house

New Questions in Engineering

Yo can someone find me an e-boy?

If the surface energy of a magnesium oxide - nickel oxide (MgO-NiO) solid solution is 1.05 J/m2 and its elastic modulus is 198 GPa, what is the maximum length of an internal elliptical flaw, in mm, if the ceramic part must survive an applied tensile

A (n) 78-hp compressor in a facility that operates at full load for 2500 h a year is powered by an electric motor that has an efficiency of 93 percent. If the unit cost of electricity is $0.

What design advantages can you identify in the location of the controller

A dam 75 ft wide, with a nominal flow rate of 260 ft3/s, is to be studied with a scale model 3 ft wide, using Froude scaling as the most important similarity parameter.