Engineering » Page 100

Engineering

Ean

Define the Static Balancing.

Answer Answers (1)

Engineering

Karley Bell

What is the specific volume of superheated steam at 300 °C and a pressure of 1.2 MPa?

Answer Answers (1)

Engineering

Justin Underwood

An insurance deductible is ...

a commission paid to the agency for the purchase

of a policy

the monthly premium on an insurance policy.

the contract fee applied to the monthly premium.

the amount you owe before insurance will cover the rest of the bill

Answer Answers (1)

Engineering

Walter Dickson

Compared to 15 mph on a dry road, about how much longer will it take for

you to stop at 30 mph on a snow-covered road?

2 to 3 times

4 to 6 times

8 to 10 times

Answer Answers (2)

Engineering

Honey

What does it mean to wire solar cells in parallel vs. wiring them in series? I always get these switched around.

Answer Answers (1)

Engineering

Skye Cooper

Two wafer sizes are to be compared: a 156-mm wafer with a processable area = 150mm diameter circle and a 312-mm wafer with a processable area = 300mm diameter circle. The IC chips in both cases are square with 10 mm on a side? Assume the cut lines (streets) between chips are of negligible width. What is the percent increase in (a) Wafer diameter, (b) processable wafer area, and (c) number of chips for the larger wafer size?

Answer Answers (1)

Engineering

Benton

A spherical container made of steel has 20 ft outer diameter and wal thickness of 1/2 inch. Knowing the internal pressure is 50 psi, estimate the maximum normal stress and the maximum shearing stress in the container

Answer Answers (1)

Engineering

Sofia Davis

When changing a tire size 195/75 R15 to a 5 percent lower profile, the correct tire size would be

Answer Answers (1)

Engineering

Zain Mata

What are the advantages of bioethanol? What food crops can be used to produce bioethanol?

Answer Answers (1)

Engineering

Denise

Who here is a genius?

Answer Answers (2)

Engineering

Zaria Simmons

to read the line voltage supplied to an appliance, you should connect the voltmeter a. in series with the power supply B. between the grounded wire and the water pipe C. across the power supply D. between terminals of two adjacent circuit parts

Answer Answers (1)

Engineering

Shiner

Which statement is true? A spontaneous abortion is the same as an induced abortion. The case of Roe v. Wade legalized abortion in all three trimesters. The AMA adopted an anti-abortion position in 1959.

Answer Answers (1)

Engineering

Zara Cuevas

A signalized intersection approach has three lanes with no exclusive left or right turning lanes. The approach has a 40-second green out of a 75-second cycle. The yellow plus all-red intervals for phase total 4.0 seconds. If the start-up lost time is 2.3s/phase, the clearance lost time is 1.1s/phase, and thesaturation headway is 2.48 s/veh under prevailing conditions, what is the capacity of the intersection approach?

Answer Answers (1)

Engineering

Aron Prince

After the 2015 AFC Championship football game between the New England Patriots and the Indianapolis Colts, it was alleged that the New England Patriots had under inflated eleven of their twelve footballs. NFL rules require that the footballs be inflated between 12.5 and 13.5 psi and the Pat's footballs were under by ~2 psi. Claims were made that the lower pressure was due to the change in temperature from the locker room were the footballs were initially inspected and the cold field where the game was played. Assuming that the footballs were properly inflated to the minimum pressure, 12.5 psi, in the locker room where it was 76.5°F (24.7°C), what would the temperature, in °C, have been on the field to explain a loss of 2 psi in pressure.

You will need to assume no change in the volume of the football and no leaks which may or may not be true.

Answer Answers (1)

Engineering

Dawson Barnes

The volume of a cylinder is to be determined from measurements of the diameter and length. If the length and diameter are measured at four different locations by means of a micrometer with an uncertainty of 0.5% of reading, determine the uncertainty in the measurement.

Answer Answers (1)