Engineering » Page 77

Engineering

Braeden Fleming

What was the Strategic Air Command?

Answer Answers (2)

Engineering

Ashley

A solid titanium alloy [G 114 GPa] shaft that is 720 mm long will be subjected to a pure torque of T 155 N m. Determine the minimum diameter required if the shear stress must not exceed 150 MPa and the angle of twist must not exceed 7 degree. Report both the maximum shear stress and the angle of twist at this minimum diameter.

Answer Answers (1)

Engineering

Mike Velez

Pouring molten aluminum into a mold and allowing it to cool forms?

Answer Answers (1)

Engineering

Cade Terrell

Suppose you have two nonempty stacks S and T and a deque D. Describe how to use D so that S contains all of the elements of T below all of its original elements. Write the code in C++.

Answer Answers (1)

Engineering

Prince Greer

List two common units of measurement to describe height

Answer Answers (1)

Engineering

Kelsey

What do you understand by gravity?

Answer Answers (1)

Engineering

Ezekiel Ryan

What is infiltration in irrigation

Answer Answers (1)

Engineering

Mike Levy

This size of battery is found in a Hybrid Electric Vehicle (HEV).

Answer Answers (2)

Engineering

Aubrie

Collin has a credit card bill of $3,000. He makes only the minimum payment and is always close to the limit on his credit card. Is Collin using credit responsibly?

Answer Answers (1)

Engineering

Rachael Villa

Air pollutants produced by mining activities, and their characteristics

Answer Answers (1)

Engineering

Annie Ewing

Write a single statement to print: user_word, user_number. Note that there is no space between the comma and user_number. Sample output with inputs: 'Amy' 5

Answer Answers (1)

Engineering

Caitlin Craig

8. What side length would you specify if you were required to create a regular

hexagonal plate that was comprised of 33 cm - of sheet metal?

Bonus: Sketch the hexagon, dimension the side length on the sketch to 0.1 cm,

and indicate your grid spacing. Justify your dimension.

Answer Answers (1)

Engineering

Joshua Wolfe

Calculate the radius of gyration for a bar of rectangular cross section with thickness t and width w for bending in the direction of (a) the thickness, (b) the width, and (c) transverse to a diagonal.

Answer Answers (1)

Engineering

Hood

For maximum comfort and safety ideally how should a driver angle their seat where forward is toward the wheel and backward is away from it?

Answer Answers (2)

Engineering

Sherlyn Ayers

A square silicon chip (k = 152 W/m·K) is of width 7 mm on a side and of thickness 3 mm. The chip is mounted in a substrate such that its side and back surfaces are insulated, while the front surface is exposed to a coolant. If 6 W are being dissipated in circuits mounted to the back surface of the chip, what is the steady-state temperature difference between the back and front surfaces?

Answer Answers (1)