Mathematics

Lilyana Glover

1 April, 05:23

A machine that produces ball bearings has initially been set so that the mean diameter of the bearings it produces is 0.500 inches. A bearing is acceptable if its diameter is within 0.005 inches of this target value. Suppose, however, that the setting has changed during the course of production, so that the distribution of the diameters produced is now approximately normal with mean 0.498 inch and standard deviation 0.002 inch. What percentage of the bearings produced will not be acceptable?

+2

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question ✅ “A machine that produces ball bearings has initially been set so that the mean diameter of the bearings it produces is 0.500 inches. A ...” in 📘 Mathematics if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.

Search for Other Answers

You Might be Interested in

When a function is graphed, the dependent variable is usually measured along the x-axis?

The table below represents the velocity of a car as a function of time. Table: Time Velocity (hour) (miles/hour) x y 0 50 1 52 2 54 3 56 Part 1: What is the y-intercept of the function, and what does this tell you about the car?

The ratios of white to blue marbles in Jais bag is 2 to 5. If there are not than 50 marbles in the bag, what is the minimum number of marbles that can be in the bag

Is this comparison true 2.29 < 2.129

Provide a counterexample to the following statement: division of whole numbers is commutative

New Questions in Mathematics

How do i factor the coefficent out of a variable, such as 2.4n+9.6 and - 6z+12

What is 10/13 + 8/13?

Simplify this equation. (x) + (x+3) + (x-2) + 3 (x+3) - 1 = 87

Solve 2^x=32 and rewrite this equation in a logarithmic form

Can each pencil have a mass of 10.5 grams in a pack of 5 pencils weighing 60 to 95 grams?