Physics

Anabel Mccoy

13 November, 00:52

Professor blossom expects her students to be on time for class holds, them for the entire class period and has firm deadlines set for reports and other assignment. Sociologically which best describes professor blossom's approach to teaching

+2

Answers (1)

Know the Answer?

Not Sure About the Answer?

Find an answer to your question ✅ “Professor blossom expects her students to be on time for class holds, them for the entire class period and has firm deadlines set for ...” in 📘 Physics if you're in doubt about the correctness of the answers or there's no answer, then try to use the smart search and find answers to the similar questions.

Search for Other Answers

You Might be Interested in

Calculate the average induced voltage between the tips of the wings of a Boeing 747 flying at 940 km/hr above East Lansing. The downward component of the earth's magnetic field at this place is 0.7·10-4 T.

Which measure of central tendency refers to the value that appears most frequently in a data set?

A train is accelerating at a rate of 2 m/s. If it's initial velocity is 20 m/s, what is its velocity after 30 seconds?

What would increase the resistance of a copper wire? A. decreasing the wire's thickness B. decreasing the wire's temperature C. decreasing the wire's length

An electric field around two charged objects is shown. What are the charges of objects X and Y?

New Questions in Physics

If a pressure gauge measure an increase in 3*10^ (5) Pa on an area of 0.7 m^2, calculate the increase in the force applied to the area?

Which of the following is an example of potential rather than kinetic energy? a. water rushing over Niagara Falls b. a molecule of glucose c. a crawling beetle foraging for food d. light flashes emitted by a firefly

If a force of 15 newtons [N] is applied to a surface and the pressure is measured as 4,000 pascals [Pa], what is the area of the surface in units of square milimeters [mm2 ]?

An engineer has the task of producing an aluminum alloy with a density of 3.0 grams per cubic centimeter. She comes up with the perfect alloy and saves a sample of it. Which mass and volume measurements correspond to this sample? 7 g and 2.

What must be your car's average speed in order to travel 235km in 3.25 hours?